Maintenance - Mettler Toledo InFlow 76X Instructions D'utilisation

24

5 Maintenance

© 04/17 Mettler-Toledo GmbH, CH-8606 Greifensee
Printed in Switzerland
Always keep electrode/sensor, housing and socket clean. Replace defective seals and
other components without delay. Information about maintenance of electrodes and sensors
is available in the corresponding operating instructions.
NOTICE
It is recommended to regularly replace the O-rings (see drawing 4) of the InFlow 762
when using the INGOLD DN25 version (all other versions do not have any O-ring seals).
O-ring gasket 53.57 3.53 FPM
Drawing 4
InFlow 76X
InFlow 76X
52 403 711