Accessories /Spare Parts; Terms Of Warranty - Mettler Toledo InFlow 76X Instructions D'utilisation

26
[°C]
180
160
140
120
100
80
60
40
20
0

7 Accessories /spare parts

8 Terms of warranty

© 04/17 Mettler-Toledo GmbH, CH-8606 Greifensee
Printed in Switzerland
Pressure/temperature diagram
PVDF
0 1 2 3 4 5
0 14.5 29 43.5 58 72.5
Designation
O-ring set for InFlow 762 (PVDF) with INGOLD DN25, EPDM
O-ring set for InFlow 762 (PVDF) with INGOLD DN25, Kalrez
O-ring set for InFlow 762 (PVDF) with INGOLD DN25, Viton
The flow-through housings employ state-of-the-art technology and are very reliable. They are
permanently revised to meet the latest technical evolutions and leave the factory only after having
passed thorough quality testing.
The warranty period of 12 months starts from the date of delivery. The warranty covers all defects
due to faulty material or manufacturing.
Normal wear or damage caused by inadequate use (such as chemical incompatibility, etc.) are
not covered by the warranty.
In any case, the warranty is limited to the replacement or repair of faulty products, depending
on manufacturer's choice. The warranty is void if the customer or any third party apply modifica-
tions to products supplied by METTLER TOLEDO. Any defect that may be subject to warranty
must be reported to the supplier without delay or, at the latest, before the warranty period ends.
InFlow 76X
1.4404 / 316L
6 7 8 9 10 11
101.5 116 130.5 145 159.5 174 188.5 203 217.5 232 [psig]
87
[°F]
356
320
284
248
212
176
140
104
68
32
12 13 14 15 16 [bar (10
Order No.
52 403 716
®
52 403 717
®
52 403 715
52 403 711
InFlow 76X
5
Pa)]
InFlow 76X