PRO-POINT PROCUT 9400805 Manuel D'utilisation page 30

9400805
Overheating. 1. Forcing the plasma cutter
2. Blocked housing vents.
3. Extension cord is too
4
Dross build-up 1. Tool/material building up
on parts of
cuts.
2. Cutting speed too slow or
3. Worn torch parts.
30
60A PROCUT Plasma Cutter
torch to work too fast.
long, or wire gauge is too
thin.
. Duty cycle exceeded.
heat.
current too high.
1. Allow the plasma cutter torch
to work at its own rate.
2. Blow dust out of the tool using
compressed air.
3. Eliminate the use of an
extension cord. If an extension
cord is needed, use one with
the proper diameter for its
length and load.
4
. Wait for the tool to cool.
Consult the specifications for
duty cycle.
1. Allow material to cool then
continue cut.
2. Increase speed and/or reduce
current until dross is reduced
to minimum.
3. Inspect and repair or replace
worn parts.
For technical questions call 1-800-665-8685
V1.0