PRO-POINT PROCUT 9400805 Manuel D'utilisation page 29

V1.0
Workpiece is 1. The cutting speed is too
not cut
through.
2. Torch electrode or nozzle
3. Cut thickness exceeds
4. Cutting nozzle is not
5. Leak from the gas circuit
The plasma 1.
cutter will not
start.
2.
3.
4.
5.
6.
Tool is making 1. The plasma cutter parts
unusual
sounds
2. Electrical components
3. Worn tool components.
Performance Damaged plasma cutter
decreases consumable components.
over time.
Visit www.princessauto.com for more information
60A PROCUT Plasma Cutter
rapid.
is burnt out.
the limit of the cutting unit.
vertical.
reduces gas/air flow.
Supplied power is
interrupted.
Fuse or breaker tripped.
The ON/OFF switch is
faulty.
Components are short-
circuiting or are
defective.
Tool has overheated.
Extension cord or power
supply cord is damaged.
may be rubbing or
binding.
may be shorting.
1. Slow down the cutting speed.
2. Replace electrode or nozzle.
3. Replace with high-power
plasma cutting unit.
4. Adjust cutting nozzle angle.
5. Examine and repair the gas
circuit.
1. Check that power supply is
still viable.
2. Replace fuse or reset
breaker.
3. Replace the ON/OFF switch.
4. Have a qualified technician
service the tool.
5. Allow tool to cool before
attempting to use. Check
duty cycle requirements.
6. Replace damaged power
cord.
1. Check for obstructions or
misaligned tool components.
Lubricate, repair or replace
the components based on the
problem.
2. Disconnect tool from the
power source immediately.
Have the tool examined by a
qualified technician.
3. Check and replace the worn
parts.
Replace components as needed.
9400805
29