PRO-POINT PROCUT 9400805 Manuel D'utilisation page 28

9400805
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
PROBLEM(S) POSSIBLE CAUSE(S)
Pilot plasma is 1. Compressed air is too
not stable
during
2. Electrode of cutting torch
operation.
3. Connection between
4. Cutting speed is too slow.
Cut is at 1. Nozzle or electrode is
wrong angle.
2. The installation position of
3. Cutting speed is too high.
4. Nozzle axis is not plumb
Cut is too 1. Cutting speed is too
wide and cut
quality is poor.
2. Torch's electrode or
3. Cutting speed is too
4. Wrong type of nozzle
28
60A PROCUT Plasma Cutter
low or too high.
or nozzle is burnt.
ground cable and
workpiece is poor.
burnt.
nozzle and electrode do
not match.
with the plane.
slow.
nozzle is burnt.
high.
used.
SUGGESTED SOLUTION(S)
1. Adjust pressure.
2. Replace electrode or nozzle.
3. Connect firmly.
4. Adjust speed.
1. Replace nozzle or electrode.
2. Correctly install both.
3. Slow down cutting speed.
4. Adjust the torch angle.
1. Accelerate cutting speed.
2. Replace electrode or nozzle.
3. Slow cutting speed. Review
4. Replace with a suitable nozzle.
For technical questions call 1-800-665-8685
V1.0