Electromagnetic Fields - Pro-Point Procut 9400805 Manuel D'utilisation

9400805
4. Take work breaks to prevent the tool from overheating and/or
overloading. Refer to the plasma cutting machine's duty cycle in
Specifications.
5. Keep hands away from the electrode and the area it is being
applied to when the tool is in operation.
6. Do not connect the plasma cutting machine ground clamp to an
electrical conduit. Do not weld on an electrical conduit.
7. Do not touch the electrode or welded surface immediately after
use. The surface will be hot and may cause an injury.
8. Never use a tool with a cracked or worn electrode. Change the
electrode before using and discard the damaged one.

ELECTROMAGNETIC FIELDS

WARNING! Stop welding immediately and move away from the
plasma cutting machine if you feel faint, dizzy, nausea or shocks.
Seek medical attention.
Electromagnetic Fields (EMF) can interfere with electronic devices such
as pacemakers. Anyone with a pacemaker should consult with their
doctor before working with or near an arc welding unit. The following
steps can minimize the effects of electromagnetic fields.
1. Twist or tape cables together and prevent coils.
2. Do not drape cables on your body.
3. Keep the cutting power source and cables as far away from the
user as practical. A minimum of 24 in. is recommended.
4. Connect the workpiece clamp as close to the weld as possible, but
lay the electrode and workpiece cables away from the user.
5. Use the appropriate current setting during cutting.
6. Avoid long and regular bursts of energy while welding. Apply the
electrode in short strokes and intermittently. This will prevent the
pacemaker from interpreting the signal as a rapid heartbeat.
7. Do not allow the electrode to touch the metal while welding.
8. Wrap the lead cable and ground cable together whenever possible.
9. Keep the lead cable and ground cables on the same side of
your body.
14
60A PROCUT Plasma Cutter
For technical questions call 1-800-665-8685
V1.0