PRO-POINT PROCUT 9400805 Manuel D'utilisation page 11

V1.0
4. Avoid welding in a work area that has vapours from cleaning,
degreasing or any spraying operations. The heat and light from
welding can react with the vapour and form irritating or potentially toxic
gases. Wait for the vapours to disperse.
5. Consult the manufacturer's Safety Data Sheets (SDS) for
instructions and precautions about metals, consumables, coatings,
cleaners and degreasers.
5.1 Do not weld on coated metals such as galvanized, lead or
cadmium plated steel, unless the coating is removed from the
weld area. The coatings and any metals containing these
elements can give off toxic fumes during the cutting process.
5.2 Do not weld, cut or heat lead, zinc, cadmium, mercury,
beryllium or similar metals without seeking professional advice
and inspection of the cutting area's ventilation. These metals
produce extreme toxic fumes, which can cause discomfort,
illness and death.
5.3 Do not weld or cut near chlorinated solvents or in areas that
chlorinate solvents can enter. The heat or ultraviolet light of the
arc can separate chlorinated hydrocarbons into a toxic gas
(phosgene) that can poison or suffocate the user or bystanders.
AIR TOOL PRECAUTIONS
1. Extended exposure to air tool noise may cause hearing loss. Ear
protection gear can reduce or eliminate the noise level.
2. Inspect the tool's air hose for cracks, fraying or other faults before
each use. Discontinue use if the air hose is damaged or hissing is
heard from the air hose or connectors, while operating the tool.
Replace the defective component/air hose.
3. Do not allow people, mobile equipment or vehicles to pass over the
unprotected air hose. Position the air hose away from high traffic
areas, in a reinforced conduit or place planks on both sides of the
air hose to create a protective trench.
4. Prevent damage to the air hose by observing the following:
4.1 Keep the air hose behind the tool and out of the tool's work
path.
4.2 Keep the air hose away from heat, oil, sharp edges or moving
parts.
Visit www.princessauto.com for more information
60A PROCUT Plasma Cutter 9400805
11