PRO-POINT PROCUT 9400805 Manuel D'utilisation page 13

V1.0
5. Only use insulated connectors to join welding cables.
6. Ensure there are no contacts between the workpiece and work
area that would allow it to ground, other than through the ground
cable circuit
7. Do not exceed the duty cycle or amperage required for the type of
welding. Excessive amperage can cause the deterioration of
protective insulation and create a shock hazard (see
Specifications).
8. Unplug the plasma cutting machine when not in use as the unit as
current is still entering the unit, even when it is turned off.
9. Frequently inspect input power cable for wear and tear, replace the
cable immediately if damaged. Bare wiring is dangerous and can kill.
10. Do not use damaged, under sized or badly joined cables.
11. Do not disconnect the power cord in place of using the ON/OFF
switch on the tool. This will prevent an accidental startup when the
power cord is plugged into the power supply.
11.1 In the event of a power failure, turn off the machine as soon as
the power is interrupted. The possibility of accidental injury
could occur if the power returns and the unit is not switched off.
12. Make certain the power source conforms to requirements of your
equipment (see Specifications).
POWER TOOL PRECAUTIONS
This equipment requires a dedicated 230-volt, 50 amp single-phase
alternating current circuit equipped with a similarly rated circuit breaker when
using single-phase power. Do not run other appliances, lights, tools or
equipment on the circuit while operating this plasma cutting machine.
1. Do not drape or carry coiled welding cables on your body when
the cables are plugged into the plasma cutting machine.
2. Do not start the tool when the electrode is touching the workpiece.
3. Hold the tool by the insulated gripping surfaces when performing
an operation where it may contact hidden wiring or its own cord
and cables. Contact with a 'live' wire will electrify exposed metal
parts and shock the operator.
Visit www.princessauto.com for more information
60A PROCUT Plasma Cutter 9400805
13