Assembly & Installation - Pro-Point Procut 9400805 Manuel D'utilisation

V1.0
condensate bowl and drain line, the compressed air supply
should be checked for issues.
Q Power switch
R Fan
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
INSTALL THE AIR SOURCE
The plasma cutter uses compressed air with the plasma arc to create
an ionized cutting arc.
1. Follow operating and set-up instructions in the compressor's manual
before connecting to the plasma cutter.
2. Connect the air hose to the air inlet (N) on the back of the
plasma cutter. Use thread sealant to prevent air leaks.
3. Install an air dryer on the compressor air hose to prevent moisture
from reaching the plasma cutter. Remember to compensate for the
slight loss of air pressure the air dryer will cause.
SET-UP PROCEDURE FOR PLASMA CUTTING
Please install the machine strictly according to the following steps.
1. Connect the plasma torch to the plasma cutting machine. Insert the
plasma torch cable connector into the euro connector port (D) and
screw hand tight. Do not bend the pins inside the torch connector.
2. Connect the ground lead to the output terminal (K) of the machine
and tighten.
3. Connect the compressed air/gas supply to the air connection (N)
located at the rear of the machine. Turn on the air/gas supply.
4. Connect the machine to the correct power supply and switch on
the machine using the ON/OFF switch (Q).
5. Determine if the gas or air is flowing. Press the cutting mode selector
button (J) to switch to Test Air (G) and the indicator will light up. Pull
the trigger and gas should flow out of the nozzle. The machine does
not supply an electric arc when in this mode.
Visit www.princessauto.com for more information
60A PROCUT Plasma Cutter 9400805
17