Installation - ACteon Sopro 717 First Manuel D'utilisation

5.1. CONNECTING
Fastening the handpiece holder:
1. Choose a smooth area that can be easily accessible for use.
2. Use the wipe provided to clean the surface on which you are going to fasten the holder.
3. Remove the double-sided adhesive tape protection that is on the support, place it, and then press it into place
several times.
The maximum adhesive performance is obtained after two hours. So, avoid any stress on the holder during this two
hour period.
!
WARNING:
This holder is equipped with magnets that can damage devices sensitive to magnetic fields. Make sure you do not
install this holder near these devices (cathode ray tube video screen, magnetic videotapes, etc.).
5.2. FURTHER CONNECTION BOXES (OPTIONAL)
You can install a connection box near each dental chair (no limitation). You will just have to transport the handpiece
from one chair to the other.
The handpiece holder is intended to maintain the connecting cable connector when the cable is not linked to the
handpiece.
When you disconnect the handpiece connecting cable to take it to another chair (or when you put the handpiece
on its holder), the last stored image displays on the screen* (or the last four if you were in four-image mode, or the
color-bar pattern if no image was stored).
(* Except for the DOCK USB2)
5.3. FOCUSING ADJUSTMENT
On the handpiece, there is a rotating ring used to focus from "0" to infinite. To simplify handling, we have preset
three positions corresponding to the main dental camera uses.
Extra-oral (Portrait).
Intra-Oral (1 to 5 teeth).
Macro (details that cannot be seen with naked eye).
10
S o p r o 7 1 7 F i r s t • U s e r ' s m a n u a l • 2 0 1 0 - 0 3 - 2 6
E N G L I S H

INSTALLATION

5