Installation - ACteon SOPROLIFE Manuel D'utilisation

5.1. CONNECTING
Fastening the handpiece holder:
1. Choose a plain area that can be easily accessible for use.
2. Use the wipe provided to clean the surface on which you are going to fasten the holder.
3. Remove the double-sided adhesive tape protection that is on the support, place it, and then press it into
place several times. The maximum sticking performances are obtained after two hours,so avoid any stress
on the holder during this two hour period.
CAUTION:
CAUTION: This holder is equipped with magnets that can damage devices sensitive to magnetic fields. Make
sure you do not install this holder near these devices (cathode ray tube video screen, magnetic videotapes,
etc.).
5.2. FURTHER CONNECTION BOXES (optional)
You can install a connection box near each dental chair (no limitation). You will just have to transport the
handpiece from one chair to the other.
The handpiece holder is intended to maintain the connecting cable connector when the cable is not linked to
the handpiece. When you disconnect the handpiece connecting cable to take it to another chair (or when you
put the handpiece on its holder), the last stored image is displayed on the screen* (or the last four if you were
in four-image mode, or the colour-bar pattern if no image was stored).
*Except on Dock USB2.
5.3. FOCUSING ADJUSTMENT
On the handpiece, there is a rotating ring used to focus from "0" to infinite. To simplify handling, we have pre-
set four positions corresponding to the main SOPROLIFE uses.
Extra-oral (Portrait).
Intra-Oral (1 to 5 teeth).
LIFE (cavities and pulp chamber observation)
Macro (details that cannot be seen with naked eye).
E N G L I S H

INSTALLATION

5
S O P R O L I F E • U s e r ' s m a n u a l
11