Installation - ACteon SOPROCARE Manuel D'utilisation

E N G L I S H

INSTALLATION

ALLA
The device is intended to be used by a dental practitioner. Its installation does not require any special training. Consult the
instructions in this manual.
5.1. CONNECTING
Fastening the handpiece holder:
1. Choose a plain area that can be easily accessible for use.
2. Use the wipe provided to clean the surface on which you are going to fasten the holder.
3. Remove the double-sided adhesive tape protection that is on the support, place it, and then press it into place several times.
The maximum sticking performances are obtained after two hours,so avoid any stress on the holder during this two hour period.
!
CAUTION :
This holder is equipped with magnets that can damage devices sensitive to magnetic fi elds. Make sure you do not install this holder
near these devices (cathode ray tube video screen, magnetic videotapes, etc.)
5.2 FURTHER CONNECTION BOXES (optional)
You can install a connection box near each dental chair (no limitation). You will just have to transport the handpiece from one chair
to the other.
The handpiece holder is intended to maintain the connecting cable connector when the cable is not linked to the handpiece. When
you disconnect the handpiece connecting cable to take it to another chair (or when you put the handpiece on its holder), the last
stored image is displayed on the screen or the last four if you were in four-image mode, or the colour-bar pattern if no image was
stored (except on Dock USB2 and Dock U_USB2).
13
SOPROCARE • User's manual