Warning And Notice Signs En; Product-Specific Hazards En; Emergency Information En - Abicor Binzel CR1000 Mode D'emploi

2 Safety
2.6 Warning and notice signs
The following warning and notice signs can be found on the product:
Symbol
These markings must always be legible. They must not be covered, obscured, painted over or removed.
2.7 Product-specific hazards
• Check the electrical device for any damage and for proper functioning in accordance with its
designated use.
• Never expose the electrical device to rain and avoid damp or wet environments.
• Protect yourself from electrical accidents by using insulating mats and wearing dry clothing.
• Never use the electrical device in areas subject to a risk of fire or explosion.
• Arc welding may cause damage to the eyes, skin and hearing. When working with the device, always
wear the prescribed protective equipment.
• Metal vapours, especially from lead, cadmium, copper and beryllium, are all harmful to health! Ensure
sufficient ventilation or extraction. Always ensure compliance with the legal limit values.
• Rinse workpieces that have been degreased with chlorinated solvents using clean water to prevent the
risk of phosgene gas formation. Do not place degreasing baths containing chlorine in the vicinity of the
welding area.
• Adhere to the general fire protection regulations and remove flammable materials from the vicinity of
the welding work area prior to starting work. Keep suitable fire extinguishing equipment at the
workplace ready for use.
2.8 Emergency information
In case of emergency, immediately disconnect the following supplies:
• Power: mains plug
• Further measures can be found in the "Power source" operating instructions or in the documentation for
other peripheral devices.
EN - 6
Meaning
Read and observe operating instructions!
CR1000/CR1250