Product Safety En - Abicor Binzel CR1000 Mode D'emploi

CR1000/CR1250
2.4 Warnings
In these operating instructions, potentially dangerous work steps are preceded by the following warnings.
Arranged in descending order of danger, they mean:
Describes an imminent threatening danger. If not avoided, it will result in fatal or extremely critical injuries.
Describes a potentially dangerous situation. If not avoided, it may result in serious injuries.
Describes a potentially harmful situation. If not avoided, it may result in slight or minor injuries.
NOTICE
Describes the risk of impairing work results or the risk that may result in material damage to the
equipment.
2.5 Product safety
• The product has been developed and manufactured in accordance with state-of-the-art technology and
the recognised safety standards and regulations. These operating instructions warn you against
unavoidable residual risks to users, third parties, devices or other material property. Disregarding these
warnings may result in risks to human life and health, environmental damage or material damage.
• The product may only be operated in an unmodified, technically perfect condition, within the limits
described in these instructions.
• Always observe limit values specified in the technical data. Overloads lead to destruction.
• Safety devices on the device must never be disassembled, bridged or otherwise bypassed.
• During welding work outdoors, use suitable protection against the weather conditions.
• Check the electrical device for any damage and for proper functioning in accordance with its
designated use.
• Never expose the electrical device to rain and avoid damp or wet environments.
• Protect yourself from electrical accidents by using insulating mats and wearing dry clothing.
• Never use the electrical device in areas subject to a risk of fire or explosion.
• Arc welding may cause damage to the eyes, skin and hearing. When working with the device, always
wear the prescribed protective equipment.
• Metal vapours, especially from lead, cadmium, copper and beryllium, are all harmful to health! Ensure
sufficient ventilation or extraction. Always ensure compliance with the legal limit values.
• Rinse workpieces that have been degreased with chlorinated solvents using clean water to prevent the
risk of phosgene gas formation. Do not place degreasing baths containing chlorine in the vicinity of the
welding area.
• Adhere to the general fire protection regulations and remove flammable materials from the vicinity of
the welding work area prior to starting work. Keep suitable fire extinguishing equipment at the
workplace ready for use.
DANGER
WARNING
CAUTION
2 Safety
EN - 5