INSTALL WATER LINE CLAMP
3
Attach the water line clamp (strain relief)(8) from
•
the kit to the refrigerator. With the clamp directly
in line with the water valve, drive the screw (7)
from the kit through the clamp(8) at the indent
into the back of the cabinet.
The metal clamp is for the house water line (see
•
Water Line Installation Instructions). It is not to
be used for the tubing from the water valve up to
the icemaker.
4
CONNECT THE WATER LINE
• Make sure there is enough plastic water line to
extend from the water valve to well into the
water tube inlet (15). Cut off any excess tubing.
• Squeeze the ends of the hose clamp (3) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1" [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water tube
inlet
Installation Instructions
7
8
3
ROUTE AND ATTACH THE
5
PLASTIC WATER LINE
Route the plastic water line along the back of
•
the refrigerator to the water tube inlet.
Fasten the plastic water line to the back of the
•
cabinet with three of the adhesive-backed
fasteners (5).
WATER VALVE INSTALLED
6
Refer to the Water Line Installation Instructions
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
57
Adhesive-backed
fasteners for plastic
water line