GE IM-6 Manuel D'utilisation Et D'installation page 55

Kit im-6 ce kit convient à la plupart des modèles appelant uk-kit-1, uk-kit-2, uk-kit-4, et à tous les modèles appelant kit im-1, im-2, im-3, im-4 ou im5ss. si vous remplacez une machine à glaçons par un kit im-1 ou im-2, reportez-vous à la page 5.
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

POWER CORD ADAPTER
5
There are two power cord adapters included with
the kit; be sure to use the one specified in the Parts
List on page 7. Plug the female end of the power
cord adapter (20) onto the male terminals on the
icemaker power cord. When connecting the adapter
to the power cord, make sure the seal is in place
between the connectors. Secure the power cord
adapter to the icemaker by putting it into the hook
at the back of the icemaker and attaching it to the
icemaker with a wire tie (22).
Hook
6
INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted)(18) into
the icemaker as shown.
7
PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall,
making sure the prongs and holes are matched. Press
the plug firmly into the socket. Lock the plug in
place by clipping the restraints onto each side of the
plug. Make sure the restraints click into place.
Installation Instructions
20
Seal
Wire tie
Hook
18
MOUNT THE ICEMAKER
8
• Lift the icemaker so the fill tube (16) fits in the
fill cup opening (E). Hang the icemaker on the
two mounting screws (C) on the mounting block.
Make sure:
• The power cord is still firmly in the socket.
• The fill tube (16) extends into the fill cup
opening on the back of the icemaker. (Check
the rear of the refrigerator to make sure the fill
tube has not been pushed out of the back of the
refrigerator).
Make sure the icemaker power switch is set to O (off).
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
9
INSTALL THE ICE BUCKET
Place the lower freezer
basket back into the
freezer drawer.
The upper freezer
basket is actually
2 baskets hooked together.
Remove basket on the left
by unhooking it.
Place the remaining
upper basket in the freezer
drawer on the right side. Place the ice bucket in
the left side of the lower basket.
10
ATTACH WARRANTY LABEL
A label (9) is provided with this kit to record the
date of installation for warranty purposes. Apply
it to the back of the refrigerator.
11
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
55
16
C
E

Publicité

Table des Matières
loading

Table des Matières