GE IM-6 Manuel D'utilisation Et D'installation page 35

5 POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List
on page 7. Plug the female end of the power cord
adapter (20) onto the male terminals on the icemaker
power cord. When connecting the adapter to the
power cord, make sure the seal is in place between
the connectors. Secure the power cord adapter to the
icemaker by putting it into the hook at the back of the
icemaker and attaching it to the icemaker with a
wire tie (22).
Hook
6 INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted)(18) into
the icemaker as shown.
7 PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the power
cord plug into the socket, making sure that the
prongs and holes are matched. Press the plug firmly
into the socket. Lock the plug in place by clipping
the restraints onto each side of the plug. Make sure
the restraints click into place.
Installation Instructions
20
Seal
Wire tie
Hook
18
MOUNT THE ICEMAKER
8
• Lift the icemaker so the fill tube extension (10)
fits in the fill cup opening (C). Hang the
icemaker on the two mounting screws (A).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube extension (10) is still in the fill cup
opening. (Check the rear of the refrigerator to
make sure the fill tube has not been pushed out
of the back of the refrigerator.)
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
THEN TIGHTEN THE ICEMAKER MOUNTING
SCREWS SECURELY.
9 INSTALL THE ICE BUCKET
Put the ice bucket in place
under the icemaker.
Make sure the icemaker
power switch is set to
O (off).
10
ATTACH WARRANTY LABEL
A label (9) is provided with this kit to record the
date of installation for warranty purposes. Apply it to
the back of the refrigerator.
11 KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
35
10
A
C