Installation Instructions - GE IM-6 Manuel D'utilisation Et D'installation

Kit im-6 ce kit convient à la plupart des modèles appelant uk-kit-1, uk-kit-2, uk-kit-4, et à tous les modèles appelant kit im-1, im-2, im-3, im-4 ou im5ss. si vous remplacez une machine à glaçons par un kit im-1 ou im-2, reportez-vous à la page 5.
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
In Canada, call 1.800.361.3400
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
instructions for local inspector's use.
IMPORTANT –
governing codes and ordinances.
Note to Installer –
instructions with the Consumer.
Note to Consumer –
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
• Completion time – 20–60 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is
not covered under the Warranty.
WHICH INSTRUCTIONS SHOULD
YOU FOLLOW?
There is a label on the back of the refrigerator
that will tell you whether to use Instructions:
C
F
G
H
J
K
Pages 10–61 contain thirteen different Installation
Instructions.
The actual installation of the icemaker will depend on
which model refrigerator you have.
Save these
Observe all
Be sure to leave these
Keep these instructions
L
M
N
P
Q
R
or
IM-6 Icemaker Kit
or
Visit our W ebsite at:
or
Visit our W ebsite at:
ARE YOU REPLACING AN
ICEMAKER WITH THIS KIT?
It's important that you use the water valve and fill tube
extension that come with this kit, even though your
refrigerator may already have them installed.
The old valve will not allow enough water through to
fill the icemaker properly and cause damage.
The fill tube extension needs to be a different length
than the original tube for proper water flow. Cut the
tube to the length indicated for your model of
refrigerator.
DAMAGE – SHIPMENT/INSTALLATION
• If the unit is damaged in shipment, return the unit
to the store in which it was bought for repair or
replacement.
• If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer.
• If the unit is damaged by the installer (if other than
the customer), repair or replacement must be made
by arrangement between customer and installer.
S
5
GEAppliances.com
geappliances.ca

Publicité

Table des Matières
loading

Table des Matières