Troubleshooting; Disposal And Recycling - Scheppach kw 7.0 Traduction Des Instructions D'origine

18. Troubleshooting

Problem Possible Cause
Saw blade is loose 1. Fixing nut not tight enough
after the motor is
switched off
Burnt areas on the 1. Blunt saw blade
cutting surface 2. Incorrect saw blade
Motor does not start 1. Mains fuse blown
2. Extension cable defective
3. Connection to the motor or switch
not OK
4. With the kw-ze 7.0: Protective cover
not mounted on Cardan shaft guard
Incorrect motor rota- Incorrect connection
tion direction
Motor not supplying 1. Overload due to blunt saw blade
power, switches itself 2. Thermal protection tripped
off automatically
Decreasing saw power Belt loose
at full speed
m Electrotechnical maintenance works should only be carried out by an electronics technician!

19. Disposal and recycling

On removal of the machine the local legal regulations have to be abided by.
Please contact the manufacturer in case of disposal.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with
the Directive (2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This can occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical and electronic equipment. Improper handling of waste equip-
ment may have negative consequences for the environment and human health due to potentially hazardous substanc-
es that are often contained in electrical and electronic equipment. By properly disposing of this product, you are also
contributing to the effective use of natural resources. You can obtain information on collection points for waste equip-
ment from your municipal administration, public waste disposal authority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste disposal company.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Help
1. Tighten fixing nut; right-hand thread
1. Sharpen/replace saw blade
2. Replace saw blade
1. Check mains fuse
2. Check extension cable, do not continue to use
defective cables, have them repaired by a profes-
sional.
3. Have this checked by an electrician.
4. Mount protective cover on Cardan shaft guard cap.
Turn phase
1. Insert sharpened saw blade.
2. Switch back on again after cool-down time
Retighten belt
GB 35