Ryobi RLT-5030AH Manuel D'utilisation page 16

RLT-5030AH_25 lgs
GB
F D E I
SPECIFIC SAFETY RULES
Do not cross roads or gravel paths with the trimmer
■
still running.
Never fit metal cutting elements to the trimmer.
■
ELECTRICAL SAFETY RULES
Make sure the cord is located so that it will not be
■
stepped on, tripped over or otherwise subjected to
damage or stress.
Do not abuse the power cord. Never carry the product
■
by the cord. Never pull the plug out of the power point
by the cord. Keep the cord away from heat, oil and
sharp edges.
For outdoors work use only suitably approved
■
extension cables with a min. conductor cross section
2
of 1.5 mm The plug connectors must have earthing
contacts and be rain-water-proof.
Inspect extension cords for deterioration, cuts or
■
cracks in the insulation. Repair or replace the cords if
any defects appear.
A nameplate on the product indicates the unit's
■
voltage. Never connect the product to an AC voltage
that differs from this voltage.
If the power cord or extension cable becomes
■
damaged during use, disconnect the cord from the
supply immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY.
Electrical power should be supplied via a Residual
■
Current Device (RCD) with a tripping current of not
more than 30 mA.
MAINTENANCE RULES
Maintain the product with care. Follow instructions
■
for changing accessories. Keep the product dry,
clean and free from oil and grease.
Unplug the product before making adjustments
■
or repairs.
Do not use the product if parts have been damaged.
■
Check the product regularly to make sure that it will
■
operate properly and perform the intended function.
Check for alignment of moving parts, binding of
moving parts, breakage of parts and any other
condition that may affect the unit operation. Inspect
the unit's power connection. Any part that is damaged
should be properly repaired or replaced by a Ryobi
authorized service centre.
Keep the product clean of grass clippings and other
■
materials that may become lodged in the cutting lines
and air vents.
13/01/06 15:42 Page 10
P NL S DK N FIN GR HU
English
CZ RU RO PL SLO HR TR EST LT
Never douse or squirt the product with water or any
■
other liquid. Do not use detergents or solvents.
Keep handles dry, clean and free from debris.
After each use, clean with a soft, dry cloth.
■
WARNING
Before carrying out any maintenance operations,
cut off the electric power supply by disconnecting
the plug from the mains.
If the cut-off blade is well worn or breaks, have this
■
replaced by contacting an authorized service centre.
SERVICE RULES
Service on this product must be performed by
■
qualified repair personnel only. Service or
maintenance performed by unqualified personnel
could result in injury to the user and/or damage to the
product. Such service may also void your warranty.
Use only identical replacement parts when servicing
■
the product. Follow the instructions in the
Maintenance section of this manual. Use of
unauthorized parts or failure to follow maintenance
instructions may create a risk of shock, serious injury
to the user and/or damage to the product. Such use
may also void your warranty.
STORAGE AND TRANSPORTATION RULES
Stop the motor when you are waiting to cut or when
■
you are walking from one cutting location to another.
Store the product inside in a dry place.
■
Store the product up high or lock it up to prevent
■
unauthorized use or damage. Keep the product out of
the reach of children.
Secure the product when transporting it.
■
Save these instructions. Refer to them frequently and
■
use them to instruct others who may use this product.
If you loan someone this product, loan these
instructions also.
10
LV SK BG