Toro Flex-Force Power System 60V MAX Mode D'emploi page 33

5. Insert 1 end of the line straight into the eyelet and push the line
through until it comes out of the eyelet on the other side.
1. Cutting line
2. Eyelet
Important:
6. Pull the line through the eyelets until there is an equal length of line
on each side of the trimmer head.
7. Hold the string trimmer in place with one hand. With your other
hand, turn the bottom of the trimmer head in the direction shown by
the arrows (clockwise) on the bottom of the bump head to wind the
line; leave about 152 mm (6 inches) extending beyond the eyelet
on each side.
Figure 16
Do not disassemble the trimmer head.
3. Eyelet alignment mark
4. Bump head alignment mark
31
g507694