Charging The Battery Pack - Toro Flex-Force Power System 60V Max Mode D'emploi

Charging the Battery Pack

Important:
The battery pack is not fully charged when you purchase
it. Before using the tool for the first time, place the battery pack in
the charger and charge it until the LED display indicates the battery
pack is fully charged. Read all safety precautions.
Important:
Charge the battery pack only in temperatures that are
within the appropriate range; refer to
Note:
At any time, press the battery-charge-indicator button on the
battery pack to display the current charge (LED indicators).
1. Ensure that the vents and charging terminals on the battery pack
and charger are clear of any dust and debris.
1. Battery-pack cavity
2. Battery-pack terminals
3. Battery-charge-indicator button
4. LED indicators (current charge)
2. Line up the cavity in the battery pack
on the charger.
3. Slide the battery pack into the charger until it is fully seated
14).
4. To remove the battery pack, slide the battery backward out of the
charger.
Specifications (page
Figure 14
5. Handle
6. Charger LED indicator light
7. Charger venting areas
(Figure
27
20).
14) with the tongue
g473274
(Figure