Toro Flex-Force Power System 60V MAX Mode D'emploi page 26

Advancing the Line Using the Bump Feed
1. Run the tool at full throttle.
2. Tap the bump head on the ground to advance the line. The line
advances each time the bump head is tapped.
Important:
running the trimmer.
Note:
The line trimming cut-off blade on the grass deflector cuts the
line to the correct length.
Note:
If the line is worn too short, you may not be able to advance
the line by tapping it on the ground. If so, release both the trigger
and the lockout switch and refer to
(page 24).
1. Bump head
Advancing the Line Manually
Remove the battery pack from the trimmer, then push the bump head at
the base of the spool retainer while pulling on the trimmer line to manually
advance the line.
Do not hold the bump head on the ground while
Figure 11
Advancing the Line Manually
24
g507693