Toro Flex-Force Power System 60V MAX Mode D'emploi page 25

Adjusting the Auxiliary Handle Position
1. Loosen the handle-lock knob on the bottom of the auxiliary handle.
2. Adjust the position of the auxiliary handle on the shaft until the
trimmer can held in a neutral, comfortable position while operating.
3. Tighten the handle-lock knob to secure auxiliary handle in place.
Adjusting the Shaft Length
1. Open the telescoping latch at the front of the handle.
2. Extend or retract the shaft until the trimmer can held in a neutral,
comfortable position while operating.
3. Close the telescoping latch to secure the shaft.
Figure 10
23
g507705