Publicité
10.2.1
Inserting the mulching insert (13)
(Fig. 13, 15, 16)
1. Lift the discharge flap (8).
2. Remove the grass collection basket (5) (if used) by
the carrying handle (5a).
3. Lift the discharge flap (8) and insert the mulching in-
sert (13).
4. Adjust the cutting height (see 9.1).
Note:
Cut the grass back by 2 cm if the grass is 4-6 cm high.
10.2.2
Difference between lawn mowing and
lawn mulching (Fig. 13, 16)
When using the mulching insert (13), the grass clippings
are not collected in a grass collection bag, but shredded
and distributed over the lawn. The nutrients contained in
the grass clippings are thus broken down by soil organ-
isms forming a nutrient cycle. Mulched lawns therefore
need to be fertilised much less frequently.
As a general rule, the lawn must be mowed relatively of-
ten so that only small amounts of mulch remain on the
lawn. It is therefore best to mulch the lawn at least once a
week and set the mower so that only approx. 40% of the
total height of the lawn is mulched. If the mulch remains
visible on the lawn (e.g. during the first cut of the year or
during heavy growth), the grass bag (5) should be used.
10.3
Safety key (14) (Fig. 1, 17)
Note:
The product can only be started if the security key is in-
serted in the product.
1. Open the cover (7).
2. Insert the rechargeable batteries (17) as described in
9.2.
3. Insert the safety key (14).
4. Close the cover (7).
WARNING
Danger of injury!
To switch off the product, switch off the motor, wait for it
to stop, remove the battery and pull out the safety key.
10.4
Blade-stop device (Fig. 1, 18)
Before each use, you must check the blade stop device.
Start the motor as described in--- FEHLENDER LINK ---.
1. Release the safety bar (1). The motor switches off and
the blade (16) is braked.
2. The blade (16) must stop within 7 seconds.
10.5
Switching the product on/off
(Fig. 18)
Note:
The charge status of the battery is indicated by the corre-
sponding LED light lighting up.
Low
High
Low battery charge status
High battery charge status
www.scheppach.com
Switching on
1. Hold the on/off button (11) depressed and pull the
safety bar (1) rearwards.
Switching off
1. Release the safety bar (1).
2. Pull out the safety key (14).
3. Remove the battery.
CAUTION
After switching off, the product will run on. Wait until the
product has come to a complete stop.
10.6
Auto/Eco mode (Fig. 1)
The product automatically starts up in the last mode used.
1. You can switch between Auto/Eco mode by pressing
the Auto/Eco switch (12).
Auto mode:
The product adjusts the motor speed to suit the load.
Eco mode:
The product runs at the lowest speed for maximum run-
time.
10.7
After mowing
• Check all screws and nuts before the next use. Tight-
en up loose screws.
• Empty the grass collection basket before the next use.
• Please also observe the chapter "Storage".
11 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
WARNING
Improper maintenance or cleaning work can
cause injuries!
WARNING
The product may start unexpectedly and cause inju-
ries and burns during cleaning, repair and mainte-
nance work.
–
Switch the product off.
–
Remove the battery.
–
Allow the product to cool.
CAUTION
Wear protective gloves when handling the
blades!
• Pull the safety key out.
GB | 29
Publicité
