Evolution R210 CMS Instructions D'origine page 9

www.evolutionpowertools.com
BLADE SAFETY
WARNING: Rotating circular saw blades are
extremely dangerous and can cause serious
injury and amputation. Always keep fingers
and hands at least 150mm away from the
blade at all times. Never attempt to retrieve
sawn material until the cutting head is in the
raised position, the guard is fully closed and
the saw blade has stopped rotating.
Only use saw blades that are recommended
by the manufacturer and as detailed in
this manual and that comply with the
requirements of EN 847-1
Do Not use saw blades that are damaged or
deformed as they could shatter and cause
serious injury to the operator or bystanders.
Do Not use saw blades that are manufactured
from high speed steel (HSS).
If the table insert becomes damaged or worn
it must be replaced with an identical one
available from the manufacturer as detailed
in this manual.
(3.6)
PERSONAL PROTECTIVE
EQUIPMENT (PPE)
Hearing protection should be worn in order
to reduce the risk of induced hearing loss.
Eye protection should be worn in order to
prevent the possibility of the loss of sight
from ejected chippings.
Respiratory protection is also advised as some
wood and wood type products especially
MDF (Medium Density Fibreboard) can
produce dust that can be hazardous to
your health. We recommend the use of an
approved face mask with replaceable filters
when using this machine in addition to using
the dust extraction facility.
Gloves should be worn when handling blades
or rough material. It is recommended that
saw blades should be carried in a holder
wherever practicable. It is not advisable to
wear gloves when operating the mitre saw.
WARNING: When using electric tools basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
personal injury including the following.
Read all these instructions before attempting
to operate this product and save these
instructions.
SAFE OPERATION
(3.7)
Always ensure that you have selected the
correct saw blade for the material being cut.
Do Not use this mitre saw to cut materials other
than those specified in this Instruction Manual.
When transporting a mitre saw ensure that
the cutting head is locked in the 90 degree
down position (if a sliding mitre saw ensure
that the slide bars are locked). Lift the
machine by gripping the outer edges of the
base with both hands (if a sliding mitre saw,
transport using the handles provided). Under
no circumstances shall the machine be lifted
or transported using the retractable guard or
any part of its operating mechanism.
Bystanders and other colleagues must be
kept at a safe distance from this saw. Cut
debris can, in some circumstances, be ejected
forcibly from the machine, posing a safety
hazard to people standing nearby.
Only use the saw with guards in good working
order, properly maintained and in position.
Before each use check the operation of the
retractable guard and its operating mechanism
ensuring that there is no damage, and that all
moving parts operate smoothly and correctly.
Keep the work bench and floor area clear of all
debris including sawdust, chips and off-cuts.
Always check and ensure that the speed marked
on the saw blade is at least equal to the no
load speed marked on the mitre saw. Under no
circumstances shall a saw blade be used that
is marked with a speed that is less than the no
load speed marked on the mitre saw.
Where it is necessary to use spacer or reducing
rings these must be suitable for the intended
purpose and only as recommended by
the manufacturer.
9
EN