Evolution R210 CMS Instructions D'origine page 8

j) Connect dust extraction equipment
• If the tool is provided for the connection of
dust extraction and collecting equipment,
ensure these are connected and properly
used.
k) Do not abuse the cord
• Never yank the cord to disconnect it from the
socket. Keep the cord away from heat, oil and
sharp edges.
l) Secure work
• Where possible use clamps or a vice to hold
the work. It is safer than using your hand.
m) Do not overreach
• Keep proper footing and balance at all times.
n) Maintain tools with care
• Keep cutting tools sharp and clean for better
and safer performance.
• Follow instruction for lubricating and
changing accessories.
• Inspect tool cords periodically and if
damaged have them repaired by an
authorised service facility.
• Inspect extension cords periodically and
replace if damaged.
• Keep handles dry, clean and free from oil and
grease.
o) Disconnect tools
• When not in use, before servicing and when
changing accessories such as blades, bits and
cutters, disconnect tools from the power
supply.
p) Remove adjusting keys and wrenches
• Form the habit of checking to see that keys
and adjusting wrenches are removed from
the tool before turning it on.
q) Avoid unintentional starting
• Ensure switch is in "off" position when
plugging in.
r) Use outdoor extension leads
• When the tool is used outdoors, use only
extension cords intended for outdoor use
and so marked.
s) Stay alert
• Watch what you are doing, use common
sense and do not operate the tool when you
are tired.
t) Check damaged parts
www.evolutionpowertools.com
• Before further use of tool, it should be
carefully checked to determine that it will
operate properly and perform its intended
function.
• Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting and any other conditions that may
affect its operation.
• A guard or other part that is damaged should
be properly repaired or replaced by an
authorised service centre unless otherwise
indicated in this instruction manual.
• Have defective switches replaced by an
authorised service centre.
• Do not use the tool if the switch does not
turn it on and off.
u) Warning
• The use of any accessory or attachment other
than one recommended in this instruction
manual may present a risk of personal injury.
v) Have your tool repaired by a qualified person
• This electric tool complies with the relevant
safety rules. Repairs should only be carried
out by qualified persons using original
spare parts, otherwise this may result in
considerable danger to the user.
(2.8)
WARNING: the operation of any power tool
can result in foreign objects being thrown
towards your eyes, which could result in
severe eye damage. Before beginning power
tool operation, always wear safety goggles
or safety glasses with side shield or a full face
shield where necessary.
LIMITATIONS ON AMBIENT CONDITIONS
The machine should be used in a covered and
dry area. The ambient temperature should be
between 15°C and 30°C. The humidity level
should be less than 60%.
MITRE SAW SPECIFIC SAFETY
(3.5)
The following specific safety instructions for
Mitre Saws are based on the requirements of
EN 61029-2-9:2012+A11.
8