Software Instructions - BIANCHI VENDING Brasilia TALIA Manuel D'emploi Et D'entretien

6.0 SOFTWARE INSTRUCTIONS

6.1 PASSWORD
The current programming logic requires, when entering by pressing the
PROG key, the insertion of a password allowing to access one programming
menu. To facilitate and speed up some operations on the field, the password
management is subdivided as follows:
PWD 1 - Reduced programming menu (00001)
PWD 2 – Sales Menu (00000)
6.2 Vending machine MENUS
PWD 1 allows to enter the dispenser menu. The procedure to enter the
menu is as follows: Press the button PROGRAMMING, enter the password
and press ENTER.
The dispenser menu is listed below.
In the programming mode the keys have the following meaning:
Membrane keypad
P1 Increase value
P2 Decrease value
P3 Move cursor
P5 Enter
P7 Escape
Keypad Touch 7":
Instructions
for User
6.3 MAINTENANCE
Maintenance is performed by pressing the key 'Service'.
In line 1 "Maintenance xxx" will be displayed , where xxx displays the boiler
temperature, and in line 2 the possible detected alarms.
Pressing twice the key Service, the stand by heating phase will be bypassed,
allowing you to perform test selections even on non regimen temperatures.
Pressing a key the slave boiler temperature will be displayed in scroll.
Keep the service button pressed for 5 seconds to reset the "coffee ground
error" alarm (all machine versions).
In the maintenance mode the keys have the following meaning:
Mechanical keypad
P1: Alarms scroll-down / 2nd level function
P2: Alarm reset
P3: Alarm history / Test run complete / 2nd level function
P4: Only water test
P5: Mixer test
P6: Group movements / Decounter recharge (2nd level function)
P7: View total selections / MDB tube filling (2nd level function)
P8: Cleaning / MDB tube emptying (2nd level function)
touch
Keypad
WARNING: the menu may differ both in terms of controls and their position,
based on the kits installed in the machine.
22
ENGLISH