Technical Data - Bosch PowerPack 300 Notice Originale

OBJ_BUCH-2087-001.book Page 2 Thursday, August 22, 2013 11:11 AM
Indication Elements, HMI
a Motor-output indicator
b Assistance-level indicator
c Illumination indicator
d Text indication
e Value indication
f Speed indication
g Battery charge-control indicator

Technical Data

Drive Unit
Article number
Rated continuous output
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
Drive Unit
Article number
Rated continuous output
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
HMI
Article number
Max. charging current,
USB connection
Charging voltage,
USB connection
Operating temperature
Storage temperature
Charging temperature
Degree of protection
Weight, approx.
Bosch eBike Systems
Lighting*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery pack in all country-specific versions,
depending on the statutory regulations
Assembly
Drive Unit Cruise Inserting and Removing the Battery Pack
0 275 007 023
For inserting and removing the battery pack in/from the
eBike, please read and observe the battery pack operating in-
W 250
structions.
Nm 60
V 36 Inserting and Removing the HMI (see figure A)
°C –5...+40
To insert the HMI 3, slide it from the front into the holder 4.
°C –10...+50
To remove the HMI 3, press the lock latch 15 and slide the
IP 54 (dust and splash HMI toward the front out of the holder 4.
water protected)
 Remove the HMI when you park the eBike.
kg 4
It is possible to secure the HMI against removal in the holder.
To do so, remove the holder 4 from the handlebars. Put the
HMI in the holder. Screw the locking screw 16 (thread M3,
Drive Unit Speed
8 mm long) from below into the thread provided in the holder.
0 275 007 021
Mount the holder back onto the handlebars.
W 350
Checking the Speed Sensor (see figure B)
Nm 60
V 36 The speed sensor 17 and its spoke magnet 18 must be
mounted in such a manner that the spoke magnet, after a turn
°C –5...+40
of the wheel, moves past the speed sensor with a clearance of
°C –10...+50
at least 5 mm, yet no more than 17 mm.
IP 54 (dust and splash
Note: If the clearance between speed sensor 17 and spoke
water protected)
magnet 18 is too small or too large, or if the speed sensor 17
kg 4
is not properly connected, the speed indication f will fail, and
the eBike drive will operate in emergency mode.
Intuvia In this case, loosen the screw of the spoke magnet 18 and fas-
ten the spoke magnet to the spoke in such a manner that it
1 270 020 909
runs past the mark of the speed sensor at the correct clear-
ance. When the speed is still not being indicated in the speed
mA 500
indication f after this, please refer to an authorised bicycle
dealer.
V 5
°C –5...+40
°C –10...+50
°C 0...+40
IP 54 (dust and splash
water protected)
kg 0.15
English–2
V 6
W 6.6
W 0.6
0 276 001 SPI | (22.8.13)