Technical Data; Inserting And Removing The Battery - Bosch HMI Mode D'emploi

OBJ_BUCH-1557-001.book Page 2 Wednesday, September 28, 2011 11:39 AM
English–2
Indication Elements, Drive HMI
a Speed indication
b Light indicator
c Assistance-level indicator
d Start-assistance indicator
e Multi-function indicator
f Assistance-mode and error code indicator
g Battery charge control indicator

Technical Data

Drive Unit
Article number
Rated continuous
output
Output torque, max.
Rated voltage
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Drive HMI
Article number
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Lighting*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery in all country-spe-
cific versions, depending on the statutory regulations
0 276 001 X45 | (28.9.11)
Assembly

Inserting and Removing the Battery

For inserting and removing the battery in/from
the the eBike, please read and observe the bat-
tery operating instructions.
Positioning the Holder of the Drive HMI
Drive Unit 45
Moving/Tilting the Holder (see figure A)
0 275 007 003
Loosen both screws 9 on the bottom side of
holder 2. Move the holder on the handlebar or
W 350
change the holder angle. Retighten both screws
9 again with a tightening torque of 1 Nm (max.).
Nm 50
V= 36
Turning the Holder (see figure B)
Loosen screw 10 on the top side of holder 2.
°C –5...+40
Turn the top part of the holder in such a manner
that the drive HMI 1 is well in your view after in-
°C –10...+50
serting it (see "Inserting and Removing the Drive
IP 54 (dust and
HMI"). Retighten screw 10 again with a tighten-
splash water
ing torque of 1 Nm (max.).
protected)
kg 4
Inserting and Removing the Drive HMI
(see figure C)
HMI
To insert the drive HMI, place it turned by approx.
1 270 020 900 30° onto holder 2 and then turn it clockwise to
the stop.
To remove the drive HMI, turn it approx. 30°
°C –5...+40
anticlockwise and pull it out of the holder 2.
°C –10...+50
IP 54 (dust and
splash water
protected)
kg 0.15
V= 6
W 2.7
W 0.3
Tighten screws 10 and 9 with a tightening
torque of 1 Nm (max.). Otherwise, the hold-
er 2 can become damaged.
Remove the drive HMI when parking the
eBike, so that the drive cannot be used by
unauthorised persons. Without the drive
HMI, the drive cannot be switched on.
Bosch eBike Systems