Bosch HMI Mode D'emploi page 28

OBJ_BUCH-1557-001.book Page 4 Wednesday, September 28, 2011 11:39 AM
English–4
Adjusting the Assistance Mode
The level of assistance of the eBike drive when
pedaling can be adjusted via the drive HMI.
Note: For individual versions, it is possible that
the the assistance mode is pre-set and cannot
be changed. It is also possible that less modes
are available for selection than listed here.
A maximum of four assistance modes are avail-
able:
"ECO": Effective assistance at max-
imum efficiency for maximum cruis-
ing range
"TOUR": Uniform assistance, for
touring with long cruising range
"SPORT": Powerful assistance for
sportive riding off road as well as
for urban traffic
"SPEED": Maximum assistance,
supporting highest cadence for
sportive riding
To change the assistance mode, press the
"mode" button 4 until the desired mode is dis-
played in indicator f.
While using the start-assistance function, indi-
cation f goes out; the set assistance mode is
stored.
Adjusting the Assistance Level
In the set assistance mode, the assistance level
can be adjusted anytime, even during riding.
Note: For individual versions, it is possible that
the assistance level is pre-set and cannot be
changed.
A maximum of three assistance levels as well as
the assistance shut-off are possible.
Assistance
degree* at:
Assistance mode "1"
"ECO" 30 %
"TOUR" 45 %
"SPORT" 70 %
"SPEED" 90 %
* The assistance degree can vary for individual versions.
0 276 001 X45 | (28.9.11)
To increase the assistance level, press the
button 6 until the desired level is displayed in in-
dicator c.
To decrease the assistance level, press the
button 7 until the desired level is displayed in in-
dicator c.
In assistance level "0", the drive is switched off.
The eBike can be operated as a normal bicycle
through pedaling.
While using the start-assistance function, indica-
tion c goes out; the set assistance level is stored.
Switching Start-assistance On/Off
Start-assistance can be used for additional sup-
port on the first meters when starting is difficult
(e.g., at a traffic light or when starting uphill). It
can also be used as a pushing aid when in the
lowest gear.
To activate the start-assistance function, press
the
tinue to hold. The eBike drive is activated, indi-
cator d flashes and indicators c, e and f go out.
Start-assistance is switched off as soon as any
of the following points occur:
– You release button
– You press another button on the drive HMI,
– You pedal in forward or quickly in backward
– The wheels of the eBike are blocked (e.g.,
– After achieving a speed of 16 km/h.
Assistance level
Switching the Lighting On/Off
"2" "3"
Depending on country-specific regulations, two
60 % 100 %
lighting versions are possible:
80 % 120 %
– The front light, rear light and display lighting
140 % 180 %
160 % 250 %
– Only the display lighting can be switched on
The start-assistance function may only be
used when starting or pushing the eBike.
Danger of injury when the wheels of the
eBike do not have ground contact while using
the start-assistance function.
button 6 longer than 1 second and con-
6,
direction,
through braking or running against an ob-
struction),
can be switched on and off at the same time
via the drive HMI.
and off; the front and rear light of the eBike
are independent of the drive HMI.
Bosch eBike Systems