Technical Data - Bosch RIDE+ Manuel Du Propriétaire

Product Features (see page 2–3)
The numbering of the components shown refers to the illustra-
tions on the graphic pages at the beginning of the manual.
All illustrations of bike parts except for the drive unit, on-board
computer including operating unit, speed sensor and the corre-
sponding holders are schematic and may differ on your eBike.
1 Joystick
2 Button "Home"
3 On-board computer
4 Holder for on-board computer
5 On/Off button for on-board computer
6 Bike lights button
7 Brightness sensor
8 USB port
9 Protective cap of USB port
10 Drive unit
11 Operating unit
12 Joystick on the operating unit
13 "Home" button on the operating unit
14 Decrease assistance level button
15 Increase assistance level button
16 Button push/start aid "WALK"
17 Lock latch for on-board computer
18 Locking screw for on-board computer
19 Speed sensor
20 Spoke magnet of the speed sensor

Technical Data

Drive Unit
Article number
Rated continuous output
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
Drive Unit
Article number
Power
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
Bosch eBike Systems
Drive Unit Cruise
0 275 007 033
W 250
Nm
V
°C –5...+40
°C –10...+50
IP 54 (dust and splash
water protected)
kg
Drive Unit Speed
0 275 007 031
W 350
Nm
V
°C –5...+40
°C –10...+50
IP 54 (dust and splash
water protected)
kg
On-board computer
Article number
Max. charging current,
USB connection
Charging voltage,
USB connection
Operating temperature
Storage temperature
Charging temperature
Degree of protection
Weight, approx.
Bosch eBike system uses FreeRTOS (see www.freertos.org)
Bike lights*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery pack in all country-specific versions,
depending on the statutory regulations
Assembly
Inserting and removing the eBike battery pack
For inserting and removing the eBike battery pack in/from the
eBike, please read and observe the battery pack operating in-
structions.
Inserting and removing the on-board computer
(see figure A)
To insert the on-board computer 3, slide it from the front into
60
the holder 4.
36
To remove the on-board computer 3, press the lock latch 17
and slide the on-board computer toward the front out of the
holder 4.
 Remove the on-board computer when you park the
eBike.
4
It is possible to secure the on-board computer against
removal in the holder. To do so, remove the holder 4 from the
handlebars. Put the on-board computer in the holder. Screw
the locking screw 18 (thread M3, 8 mm long) from below into
the thread provided in the holder. Mount the holder back onto
the handlebars.
60
36
Checking the Speed Sensor (see figure B)
The speed sensor 19 and its spoke magnet 20 must be
mounted in such a manner that the spoke magnet, after a turn
of the wheel, moves past the speed sensor with a clearance of
at least 5 mm, yet no more than 17 mm.
4
English–2
Nyon
1 270 020 907
mA 500
V
°C –5...+40
°C –10...+50
°C 0...+40
IP x7 (watertight)
kg 0.2
V
W 8.4
W 0.6
0 276 001 SPN | (17.7.14)
5
6