Power Supply Of External Devices Via Usb Connection - Bosch PowerPack 300 Notice Originale

OBJ_BUCH-2087-001.book Page 6 Thursday, August 22, 2013 11:11 AM
Code Cause
530 Battery pack error
531 Configuration error
540 Temperature error
550 An improper load was detected.
602 Internal battery pack error while
charging
602 Internal battery pack error
603 Internal battery pack error
605 Battery pack temperature error
605 Battery pack temperature error while
charging
606 External battery pack error
610 Batter pack voltage error
620 Charging error
640 Internal battery pack error
655 Multiple battery pack errors
656 Software version error
No display Internal error of the HMI
Power Supply of External Devices
via USB Connection
With the USB connection, it is possible to operate and charge
most devices whose power supply is possible via USB (e.g.,
various mobile phones).
Prerequisite for the charging is that the HMI and a sufficiently
charged battery pack are inserted in the eBike.
Bosch eBike Systems
Corrective Measure
Switch off the e-Bike, remove the battery pack and reinsert the battery
pack. Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
The eBike is outside of the permissible temperature range. Switch off the
eBike system and allow the drive unit to either cool down or heat up to the
permissible temperature. Restart the system. If the problem persists,
contact your Bosch eBike dealer.
Remove load. Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Unplug the charger from the battery pack. Restart the eBike system. Plug
the charger into the battery pack. If the problem persists, contact your
Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
The eBike is outside of the permissible temperature range. Switch off the
eBike system and allow the drive unit to either cool down or heat up to the
permissible temperature. Restart the system. If the problem persists,
contact your Bosch eBike dealer.
Unplug the charger from the battery pack. Allow the battery pack to cool.
If the problem persists, contact your Bosch eBike dealer.
Check the wiring. Restart the system. If the problem persists, contact
your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Replace the charger. Contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Switch off the eBike system. Remove the battery pack and reinsert it.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Contact your Bosch eBike dealer so that he can perform a software
update.
Restart your eBike system by switching it off and back on.
Open the protective cap 8 of the USB port on the HMI. Con-
nect the USB port of the external device to the USB socket 7
on the HMI using a standard-compliant Micro A/Micro B USB
2.0 cable. Using a USB cable that is not standard-compliant or
a cable/adapter combination can lead to damage to the HMI.
English–6
0 276 001 SPI | (22.8.13)