Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SMX 6208
•
Make sure that the plug is connected to the outlet and that the starting switch (24)
is on "0" position (off ).
•
Remove the accessory from the motor pin (if installed).
•
Place the safety cover (15) in its respective housing and remove the cover (6).
•
Insert the base (B) into the container (7).
•
Place the empty container (7) on the motor base (1) and rotate it clockwise until you
hear the hooking "click".
The container (7) handle must be
place as shown in the picture.
•
Insert the accessories-holding shaft (8) in the container (7).
•
Apply the desired accessory:
-
steel blade (9);
-
blades-holding disc (11).
The steel blade (9) and disc (11) blades are very sharp; use them
extremely carefully.
The steel blade (9) and disc (11) blades are very sharp; use them
extremely carefully.
USE AS ROBOT
7
B
7
1
EN
6
131
Publicité
Table des Matières
