The Minimum Number Of Crimpings To Be Carried Out Per Cable End; Warranty And Guarantee - NovoPress HPA400 Manuel D'utilisation

Pos : 62 /System/T abelle Verpr ess ung en/Tabell e Ver press ungen-HPH 400S @ 2\mod_1452156277205_18.doc x @ 17093 @ 1 @ 1
12 The minimum number of crimpings to be carried out per
cable end

The minimum number of crimpings to be carried out per cable end

Cross
section
mm²
16
25
35
50
70
95
120
150
185
240
300
400
* Cable lugs according to DIN 46234 must only be crimped once.
Pos : 63 /System/Gewährl eistung und Garantie/01a- Übersc hrift + 1.ter Satz - HPA400-das @ 3\mod_1470376205110_18.doc x @ 22630 @ 1 @ 1
•

13 Warranty and guarantee

Novopress provides the full statutory warranty of 24 months for its HPA400 and tools. The warranty
period always commences on the date of delivery, which must be proven by means of the sales
documentation in case of doubt.
Pos : 64 /System/Gewährl eistung und Garantie/02 - 2.ter T eil vom 1.ten Abs chnitt - all e-Sys tem @ 3\mod_1470376501986_18.doc x @ 22674 @ @ 1
•
Within the warranty period, the warranty covers the repair of any damage or malfunction of these tools
that is attributable to material or production faults.
The following are not covered by the warranty:
• Damage caused by improper use or inadequate servicing.
• Damage caused by the use of products not approved by Novopress for use with its
HPA400.
• Damage caused by pressing unsuitable cable lugs and press fittings.
For wearing parts, the Novopress warranty lasts only for the intended service life.
Service work and parts provided in response to warranty claims do not have to be paid for. However,
all shipping costs shall be borne by the user.
Claims can only be accepted if the device is delivered to Novopress or a Novopress workshop in an
assembled state.
Repair or replacement of the device under warranty does not result in an extension of the warranty
period. Repair or replacement can only be performed using as-new components, the function of which
corresponds to that of the old components. All parts that are faulty and consequently replaced are the
property of the manufacturer.
Pos : 65 /System/EG-Konformitätser kl ärung/01a Konformi tätser kl ärung-1 Ger ät @ 3\mod_1473933325348_18.doc x @ 24886 @ 1 @ 1
•
Press cylinder HPH400S
V crimpings
Cu Al
<80 N/mm² >80 N/mm²
1 --
1 --
1 --
1 2
1 3
1 3
2* 4
2* 4
2* 4
2 4
2 4
2 4
Hexagonal crimpings in
accordance with
DIN 48083, Part 4
Tool ID
Cu Al
-- 8 10
-- 10 12
-- 12 14
2 14 16
2 16 18
2 18
22
3 20
3 22 25
3 25 28
3 28 32
3 -- --
3 -- --
23
HPA400
Cu Al
Cable lug Cable lug
DIN 46235 DIN 46239
connector connector
DIN 46267 DIN 46267
Part 1 Part 2
1 --
1 2
1 3
2 3
2 3
2 4
2 4
2 5
3 5
3 --
-- --
-- --
EN