NovoPress HPA400 Manuel D'utilisation page 20

HPA400
EN
Pos : 32 /System/Kurz beschr eibung/Bild- 01/Besc hriftung Bild 2 + 3 @ 3\mod_1470815415385_18.doc x @ 22822 @ @ 1
Pos : 33 /RVT/Kurz bes chr eibung/Akku allgemei n/Akku abnehmen + aufsetzen/ACO102, ACO152, AC O/ECO202, AC O202XL, AF P/EFP202 @ 0\mod_1382442983216_18.doc x @ 1433 @ @ 1
Removing the battery (Fig. 2)
Push in (1) the two release buttons (A) and then remove the battery (2).
Inserting the battery (Fig. 3)
Slide the battery into the device as illustrated until it clicks into place.
Pos : 34 /RVT/Kurz bes chr eibung/Akku allgemei n/Akku Z ustands anzeig e/AC O/ECO202, AC O202XL, AC O/ECO203 @ 0\mod_1382445046754_18.doc x @ 1446 @ @ 1
Battery charge indicator (Fig. 2)
The battery charge is displayed when button (B) is pressed. The number of LEDs lit up denotes the
battery charge. One flashing LED indicates a maximum power reserve of 10%. The battery must be
charged soon.
If the battery is inserted in the press device while the battery charge is being checked, the last
pressing operation must have been completed at least 1 minute prior to this. Otherwise the display will
be inaccurate.
Pos : 35 /System/Kurz beschr eibung/Gerät + Akku/Info welcher Akku/18V: H PA400 @ 3\mod_1470209092024_18.doc x @ 22395 @ 2 @ 1
7.5 HPA400 and battery
Pos : 36 /System/Kurz beschr eibung/Gerät + Akku/längere Nichtbenutzung/H PA400 @ 3\mod_1470061175281_18.doc x @ 22203 @ @ 1
Behaviour of the HPA400 after extended periods out of use or when changing the battery:
If the HPA400 is out of use for approx. 30 seconds or the battery is reinserted, it switches off. No LED
is lit up any longer. Press the start button (1) briefly to turn on the HPA400.
Pos : 37 /System/Kurz beschr eibung/Gerät + Akku/entl adener Akku/H PA400 @ 3\mod_1470206833990_18.doc x @ 22306 @ @ 1
Behaviour of the HPA400 when the battery is empty:
When a pressing operation begins, a check is made to determine whether the battery charge is
sufficient to complete the pressing operation. If this is not the case the device does not start. The
green LED (2) flashes.
If the green LED (2) flashes following a pressing operation, the pressing operation was still carried out
correctly. The battery must be recharged prior to the next pressing operation.
Pos : 38 /RVT/Allgemeines /#### Seitenumbr uch #### @ 0\mod_1380200837280_0.doc x @ 885 @ @ 1
B
A
1
Fig. 2
Information
The HPA400 must only be operated with 18 V lithium-ion rechargeable batteries.
The 18 V battery must only be used in the appropriate devices.
1
2
18
Fig. 3