Ordering Replacement Parts; Disposal And Recycling; Maintenance, Cleaning, Repair - EINHELL BT-LC 400 Mode D'emploi

Anleitung BT-LC 400_SPK1:_
GB
cradle (6) completely to its initial position.
Remove the saw wood from the feed cradle (6).
To turn the saw off again, press the red button "0"
(14).
8.2. Changing the saw blade (Figs. 11-13)
Please note: Remove the power plug!
Allow the saw blade to cool before you change it.
Do not use inflammable liquids to clean the saw
blade.
Always wear gloves when handling saw blades.
Risk of injury!
Remove the screws (15) from the cover plate (16)
with the wrench (17) and take off the cover plate.
Place the face spanner (18) on the outer flange
(19) and hold securely while you undo the nut (20)
in anticlockwise direction with the spanner (17).
Take the nut (20) and outer flange (19) off the saw
shaft (21).
The saw blade (4) can now be taken off the saw
shaft (21).
Carefully clean the inner flange (22), outer flange
(18) and nut (20).
Fit the new saw blade following the above
instructions in reverse and tighten the nut (20).
Important: Do not tighten the nut by tapping
on the tool or tool extensions! Check that the
blade (4) rotates in the correct direction!
Important! Do not forget to remove your tools!

9. Maintenance, cleaning, repair

Important! Pull out the power plug first.
Remove dirt regularly from the machine. Use a hand
brush or cloths for this purpose. Check the saw blade
for signs of wear at regular intervals.
Blunt saw blades must be sharpened. Clean
resinified saw blades.
Check that all screw connections are secure at
regular intervals.
Keep the handles dry and free of resin, oil and
grease at all times. Never use caustic cleaning
products for cleaning purposes.
The saw must be covered with a tarpaulin if it is left
in unprotected areas or in outdoors. It is particularly
important to protect the motor and switch from water
contact.
Important: Repairs to electric tools may only be
carried out by a trained electrician.
16
12.11.2007 13:52 Uhr Seite 16

10. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

11. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.