Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Anleitung_NFF_1200_SPK7:_
GB
8.4.4 Adjust the scale
Every scale on the crosscut and miter saw should be
checked and adjusted if necessary.
Undo all the fastening screws for the scales.
Adjust the saw precisely to an angle dimension,
realign the angle scales and tighten the screws
again.
Check the settings by completing test cuts.
8.4.5 Adjust the splitter
The splitter can be adjusted as shown in Fig. 69. The
dimensions shown in graphic 46 must be obeyed for
this purpose.
9. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
10. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
10.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
10.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
32
14.01.2009
11:10 Uhr
Seite 32
10.3 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
11. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
Publicité
Table des Matières
