EINHELL BT-LC 400 Mode D'emploi page 14

Anleitung BT-LC 400_SPK1:_
GB
Refit all guards and safety devices immediately
after you have completed any repairs or
maintenance work.
Be sure to observe the safety information and
operating and maintenance instructions issued by
the manufacturer, as well as the dimensions listed
in the Technical Data.
It is imperative to observe the accident prevention
regulations in force in your area as well as all
other generally recognized rules of safety.
Note the information published by your
professional associations (VBG 7j).
The circular saw has to be connected to a 230 V
socket with a 16 A fuse.
Do not use any low-powered machines for heavy
duty work.
Do not use the cable for purposes for which it is
not designed.
Make sure you stand squarely and keep your
balance at all times.
Check the tool for damage.
Each time before re-using the tool, carefully check
that the guards or any slightly damaged parts are
working as intended.
Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted
correctly and that all other operating conditions
are properly fulfilled.
Unless otherwise stated in the operating
instructions, damaged safety devices and parts
must be repaired or replaced by an authorized
service center.
Have damaged switches replaced by a customer
service workshop.
This electric tool complies with the pertinent safety
regulations. Repairs are to be carried out only by
a qualified electrician using original replacement
parts or the user may suffer an accident.
If necessary, wear suitable personal protection
equipment. This could consist of:
- Ear plugs to prevent the risk of damaging your
hearing;
- A breathing mask to avoid the risk of inhaling
hazardous dust.
- Always wear gloves when handling saw blades
and rough materials. Whenever practicable, saw
blades must be carried in a container.
The operator must be informed about the
conditions that influence the generation of noise
(for example saw blades designed to reduce noise
emissions, caring for blades and the machine).
Faults on the machine or its guards, safety
devices and blade must be reported to the person
in charge as soon as they are discovered.
Use only the transport devices to move the
14
12.11.2007 13:52 Uhr Seite 14
machine. Never use the guards for handling and
moving the machine.
All operators must receive proper training in the
use, adjustment and operation of the machine.
Do not saw any materials that contain foreign
bodies such as wires, cables or ties.
Only use sharp saw blades.
Important:
Risk of injury!
Never reach into the
running saw blade.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Sound pressure level L
pA
Sound power level L
WA
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.
mode
86,5 dB
97,5 dB