Cleaning And Storing The Device And Cuff - Beurer SR BM1 Mode D'emploi

Step 1: SR BM 1
Activate Bluetooth
chapter 4 "Preparing the measurement, Blue-
tooth ").
®
Step 2: "beurer HealthManager" app
In the "beurer HealthManager" app, add the
SR BM 1 under "Settings/My devices".
Step 3: SR BM 1
take a measurement.
Step 4 SR BM 1:
data transfer immediately
following measurements.
• If Bluetooth data trans-
®
fer has been activated,
data is transferred after
having confirmed the user
memory and pressing the
START/STOP button
on your device (see
®
Step 4 SR BM 1:
Data transfer at a later point:
• Go to memory mode
(chapter 7). Select the
desired user memory. The
Bluetooth transfer starts
®
automatically.
.
The "beurer HealthManager" app must be active to allow
data transfers.
If your smartphone has a protective cover, remove this to en-
sure that there is no interference during the transfer. Begin the
data transfer in the "beurer HealthManager" app.
System requirements for the "beurer HealthManager" app
• iOS ≥ 8.0, Android
TM
• Bluetooth ≥ 4.0
®

8. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under wa-
ter, as this can cause liquid to enter and damage the device
and cuff.
• If you store the device and cuff, do not place heavy objects
on the device and cuff. Remove the batteries. The cuff line
should not be bent sharply.
In such cases, repeat the measurement and/or data transfer.
Ensure that the cuff line is correctly attached and that you do
not move or speak during the measurement.
30
≥ 4.4