Replacing The Batteries - Dogtra iQ No Bark Collar Guide D'utilisation

- When the iQ No Bark collar is first activated by the dog's bark, the unit
will give a warning non-stimulating vibration. If the dog continues to bark,
the unit will give a non-stimulating vibration followed by a correction at
the level it is set on.
* The iQ No Bark Collar has a preset delay of 15 seconds in-between
corrections. Once the unit activates, it WILL NOT activate again until 15
seconds has gone by. (The unit will reset to the warning non-stimulating
vibration after 17 seconds of a correction if the dog does not bark.)
TESTING THE IQ NO BARK COLLAR
- Turn the On/Off and Intensity Dial to (T), for the test mode. The LED
indicator will flash once, and after 2 seconds it will continue flashing every
2 seconds.
- Activate the collar by making sounds directly into the mic. The unit should
now vibrate twice. After waiting 15 seconds, repeat the test once more to
verify that it is fully functional.
* When on the test mode, the sensor may be sensitive enough that it may
activate easily by a quiet sound or tap.
ATTACHING THE COLLAR STRAP
Pull the strap around the body
of the iQ No Bark Collar in the
direction shown.
Hold strap here
1. With the On/Off 2. Pull the collar strap
Intensity Dial going from the opposite
in first, insert the side of the On/Off
body of the iQ No Intensity Dial over the
Bark Collar into the rest of the body.
collar strap.
* For video instructions on how to attach the collar strap, please visit
www.dogtra.com/iqpet
12
Hold strap here
3. Be sure that the collar
strap is wrapped
fully around the body
of the iQ No Bark
Collar.

REPLACING THE BATTERIES

* ATTENTION
- When the batteries are placed incorrectly, the LED indicator light may turn
on, but the unit will not operate properly.
- The unit is working properly when the LED Battery life indicator blinks
once. When the LED Battery life indicator blinks twice consecutively, the
battery will need to be replaced.
- Please remove the plastic battery seals before installing the batteries.
PROPER FIT
TROUBLESHOOTING
1. When do I replace the batteries on my iQ No Bark Collar?
- If the unit is not activating or the LED indicator does not turn on, the
batteries may need to be replaced. Overall battery life will be dependent on
usage. With the iQ No Bark Collar activating around 10 times a day, the
battery will have an average life of about 2-weeks.
- To clean the iQ No Bark Collar, make sure the battery cover is closed and
fully sealed, and wipe down the unit with a damp cloth and some alcohol.
Make sure the unit is completely dry before use.
- Using a coin, unscrew the battery cover
counterclockwise.
- Insert two batteries with the plus sides
facing out.
- Check to make sure that the rubber
gasket is in place, and screw in the
battery cover clockwise.
A proper fit is necessary for the iQ
No Bark Collar to work optimally.
Both contact points must be in contact
with your dog's skin at all times for a
consistent stimulation. A loose fitting
collar can cause the contact points to rub
against the skin and cause irritation.
13