Cleaning And Care - DS Produkte CJ-661 Mode D'emploi

EN
Hot Instant Beverages
To make hot instant beverages such as instant coffee, pour the amount you want into a
cup and brew it using hot water from the samovar (see the "Operation" chapter | "Oper-
ating the Discharge Tap").

Cleaning and Care

PLEASE NOTE!
■ Before commencing the cleaning, note the safety instructions in the "Safety
Instructions" chapter!
■ Regularly descale the device.
■ The device and accessories are not suitable for dishwasher use.
■ Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to
clean the device. These can damage the surface.
1. Fully empty the device.
2. Wipe down the housing with a damp cloth. If necessary, use a little mild detergent to
remove more intense soiling.
3. Rinse out the water reservoir (3) well with clear water.
PLEASE NOTE! When you do this, do not immerse the base (6) of the device in
water!
4. Clean the teapot (1), the lid, the drip tray (7) and its cover (8) with warm water and
mild detergent.
5. Dry all parts properly before the device is reassembled and / or stored away.
6. Check the mains cable regularly for any damage.
Descaling
Limescale deposits have an adverse effect not only on the quality of the tea and the
water, but they also cause power losses and shorten the lifespan of the device. We
therefore recommend regularly removing limescale deposits with a descaling agent in
accordance with the water quality in your area and how often the device is used.
The fi rst indications that descaling is required are a large amount of steam being pro-
duced and slower boiling of the water. Limescale deposits on the bottom of the reservoir
in samovars can cause the device to switch off prematurely.
1. Fill the water reservoir (3) up to the Max marking on the fi ll-level indicator (12) with
a concentrate/water solution. In doing this, it is essential to follow the details for the
descaling agent!
2. Follow the instructions in the "Preparation" chapter.
3. As soon as the solution has boiled, switch off the device by pressing the On / Off
switch. Let the solution take effect for a little while.
4. Allow the solution to run through the discharge tap (10) so that it is also freed of any
limescale residues (see the "Operation" chapter | "Operating the Discharge Tap").
5. To rinse the device, allow two tankfuls of clear water to run through it. The device is
now descaled and ready to be used again.
22