Care And Descaling - DS Produkte Z 05295 Mode D'emploi

EN
1. Place the appliance on a level, fi rm and heat-resistant surface.
2. Connect the appliance to a mains socket that has been properly installed.
3. Open the water reservoir and fi lter compartment cover.
4. Pour the desired amount of water into the water reservoir. On the water level indication,
you can see how many cups of water you have already poured into the water reservoir.
5. Place the permanent fi lter or a paper fi lter into the fi lter compartment and fi ll it with the
desired amount of coffee powder. Make sure that the permanent fi lter or paper fi lter
are inserted correctly so that the water can run through the fi lter without any problems.
6. Then close the water reservoir and fi lter compartment cover.
7. Place the glas pot on the hotplate.
8. Push the On/Off button once to switch on the coffee machine.
9. The On/Off button will light up and the brewing process will start immediately.
10. After the brewing process, you can take the glas pot from the hotplate and serve
the coffee.
11. To Switch off the coffee machine after the brewing process or if you want to switch
off the hotplate push the On/Off button one more time. The light of the On/Off button
goes out when the coffee machine is switched off.
12. Clean the appliance after use as described in the "Care and Descaling" chapter.

Care and Descaling

PLEASE NOTE!
■ The hotplate is very hot after use! Let it cool down fi rst before cleaning it.
■ The permanent fi lter is hot after use! Allow it to cool down fi rst before you remove it
for cleaning.
■ Never immerse the appliance, the power cable or plug in water.
■ Remove the plug from the mains socket before cleaning the appliance.
■ Do not use corrosive or abrasive cleaning agents to clean the appliance. These
could damage the surface.
1. Make sure that the appliance is switched off and not connected to the mains power.
2. Open the fi lter compartment by folding the water tank and fi lter compartment cover
up and pushing the water spout back.
3. Remove the permanent fi lter or paper fi lter and dispose of the used coffee powder.
4. Clean the permanent fi lter and the glas pot with hot water and a little detergent if
necessary. Do not clean the parts in the dishwasher!
5. Then dry the permanent fi lter and the glas pot thoroughly.
6. Place the permanent fi lter back into the coffee machine when they are completely dry.
7. If necessary, wipe the coffee machine and hotplate with a damp cloth and then dry
them with a dry cloth.
Descaling
If the water only runs very slowly through the appliance or the appliance is louder than
usual during the brewing process, you should descale the appliance. Use a standard
commercial descaling agent for coffee machines to descale the appliance.
16