Care And Decalcifying - DS Produkte CM-111A Mode D'emploi

EN
■ Always let the coffee maker cool off for a few minutes between two brewing proces-
ses before using it again.
■ Do not add any water to the coffee maker once it has been turned on. You could
scald yourself with the sudden emission of steam.
■ Never use the device with an empty water tank; the pump could be damaged if the
device is operated without water.
■ Do not overfi ll the permanent fi lter to prevent the fi lter from overfl owing.
■ Do not overfi ll the water tank to prevent the thermo cup from overfl owing! Always fi ll
the water tank with an amount of water that the cup (thermo cup etc.) located under the
coffee spout is capable of holding!
The device automatically deactivates after the brewing process. It has overheat
protection that prevents reactivation directly after the brewing process for reasons
of safety. Therefore, wait a few minutes after the brewing process for the device
to cool down before starting another brewing process.
1. Place the device on a dry, level and heat-resistant base.
2. Connect the device to a properly installed socket.
3. Open the water tank cover and add some water to the water tank.
4. Place the permanent fi lter holder in the fi lter compartment.
5. Place the permanent fi lter in the permanent fi lter holder.
6. Add a coffee pad or loose coffee grounds to the permanent fi lter.
7. Close the water tank cover.
8. Place the thermo cup (without the cover!) under the coffee spout.
9. Push the Power switch to switch the coffee maker on. The Power switch will illumi-
nate and the brewing process will begin immediately.
10. The brewing process is complete when no more coffee fl ows into the coffee cup.
The device automatically deactivates after the brewing process. The Power button
will go out once the device is switched off.
11. Remove the thermo cup and put the cover onto the thermo cup. The lid has a drin-
king aperture. Simply push the lid cover forward or backward to open or close the
drinking aperture.
12. After use, clean the device as described in the chapter "Care and decalcifying".

Care and decalcifying

ATTENTION!
■ The permanent fi lter and the permanent fi lter holder are hot after use! Let them cool
off before removing them for cleaning.
■ Never submerge the device, the mains cord or the plug in water.
■ Prior to each cleaning, pull the plug out of the socket.
■ When cleaning, do not use any corrosive or abrasive cleaners. They could damage
the surface.
1. Ensure that the device is switched off and disconnected from the power supply!
SKMEST_DE-EN-FR-NL_A5_V3.indb 18 SKMEST_DE-EN-FR-NL_A5_V3.indb 18
18
19.07.2016 16:07:44 19.07.2016 16:07:44