Cleaning The Device; Use - DS Produkte CM-111A Mode D'emploi

Cleaning the device

ATTENTION!
■ Before using the device for the fi rst time, be sure to observe the notes in the chapter

"Use".

■ Observe the instructions in the chapter "Care and decalcifying the device" before
fi rst cleaning.
■ The device has overheat protection that prevents reactivation directly after the brew-
ing process for reasons of safety. Therefore, wait a few minutes after the brewing
process for the device to cool down before starting another brewing process.
■ When cleaning, do not use any corrosive or abrasive cleaners. They could damage
the surface!
• Clean the permanent fi lter, the permanent fi lter holder and thermo cup with warm
water and a small amount of detergent.
• Thoroughly dry the permanent fi lter, the permanent fi lter holder and the thermo cup.
• Place the permanent fi lter and permanent fi lter holder back in the device once it is
completely dry.
• Before fi rst use, we recommend fi lling the water tank two to three times, each time
allowing the water to circulate (without coffee powder/coffee pad) in order to rinse
out the lines etc. and remove any production residue.
1. Place the device on a dry, level and heat-resistant base.
2. IMPORTANT: Place a cup or similar under the coffee spout before you con-
nect the device to a socket as the device will begin with the brewing pro-
cess right away if the On/Off button switch has been pushed before the
device was connected and the device is connected to a socket.
3. Fill the water tank with water.
4. Connect the device to a properly installed socket.
5. Press the Power switch.
6. The device will automatically deactivate once the brewing process is complete.
7. Wait a few minutes before you repeat the cleaning process.
Use
ATTENTION!
■ Do not leave the device unattended so that you can immediately intervene in the
event of malfunctions (e.g. overfl owing etc.).
■ Caution: Risk of emitted steam! Never open the water tank cover when the device is
in use! Hot steam or hot splash water may escape.
■ Before start-up, make sure that the water tank cover is closed and the permanent
fi lter as well as the permanent fi lter holder have been correctly inserted so that the
water is able to circulate through the coffee powder/coffee pad without any obstruc-
tions.
SKMEST_DE-EN-FR-NL_A5_V3.indb 17 SKMEST_DE-EN-FR-NL_A5_V3.indb 17
17 EN
19.07.2016 16:07:44 19.07.2016 16:07:44