Cleaning And Descaling - DS Produkte CM-1609 Mode D'emploi

EN
The device saves the set timer time. This can be reactivated at any time by briefl y
pressing the Uhr / Timer (clock / timer) button (21).

Cleaning and Descaling

CAUTION!
■ Danger of burns! The hotplate, the permanent fi lter, the fi lter holder, the fi lter com-
partment and the fi lter cover are hot during the brewing process and immediately
afterwards. There may also be hot water inside the permanent fi lter and fi lter holder.
Only touch any of the parts once they have cooled down.
■ The device is not dishwasher-safe. Only the coffee jug, the fi lter cover, the permanent
fi lter and the fi lter holder can be cleaned in the dishwasher.
■ Never immerse the device, the mains cable or the mains plug in water.
■ Remove the mains plug from the plug socket before cleaning the device.
■ Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
1. Make sure that the device is switched off and not connected to the mains power!
2. Remove the fi lter holder (10) from the fi lter compartment (9).
3. Remove the permanent fi lter (11) from the fi lter holder (10) and dispose of the coffee
grounds.
4. Clean all removable accessories with hot water and a little detergent or in the dish-
washer.
5. Wipe down the housing of the device and the hotplate (7), the fi lter compartment (9)
and the coffee bean container (3) with a damp cloth if necessary and then dry them
with a dry cloth.
Descaling
If the water only runs very slowly through the device or the device is louder than usual
during the brewing process, it needs to be descaled. Use a standard descaling agent for
coffee machines to do this.
1. Pour a mixture of water and descaling agent into the water tank and switch on the
device (without any coffee powder). Consult the instructions for using the descaling
agent with regard to the ratio of water to descaling agent.
2. Allow all of the mixture to run through and repeat this process if necessary if the water
still runs through slowly.
3. After descaling, let water (without coffee powder) run through the device at least
three times to fl ush the lines, etc.
26