DS Produkte CM-1609 Mode D'emploi page 23

Pouring Water into the Water Tank
CAUTION!
■ Danger of scalding from steam escaping! Never open the water tank cover when
the coffee machine is switched on. Do not pour any water into the water tank while
the coffee machine is hot! Hot steam or hot spray water may escape. Always switch
the device off fi rst and allow it to cool down before topping up the water.
■ Before you fi rst operate the device, make sure that the water tank cover is closed and
that the fi lter cover, the permanent fi lter and the fi lter holder are inserted correctly so
that the water can run through the coffee powder without any problems.
■ Never switch on the device without water in the water tank. The pump may be dam-
aged. Fill the water tank at least up to the bottom marking.
■ Do not overfi ll the water tank! Note the MAX marking in the water tank.
1. Open the water tank cover (2).
2. Pour fresh drinking water into the water tank. The amount of water must be between
the bottom and top marking of the water level indicator (6).
3. Flip the water tank cover (2) shut.
Making Coffee
CAUTION!
■ Danger of burns! The hotplate, the permanent fi lter, the fi lter holder, the fi lter com-
partment and the fi lter cover are hot during the brewing process and immediately
afterwards. There may also be hot water inside the permanent fi lter and fi lter holder.
Only touch any of the parts once they have cooled down.
■ Danger of injury due to sharp blades! Do not reach into the grinding mechanism
and do not insert any objects into the grinding mechanism! Never hold the blades
with bare hands.
• The brewing process can be stopped anytime by pressing the
Start / Stopp (start / stop) (17) button. In this case the control lamp next to
the Start / Stopp (start / stop) button (17) goes out.
• The device has overheating protection which prevents the device from being
switched on again directly after a brewing process for safety reasons. After
a brewing process, wait for a few minutes until the device has cooled down
before you start another brewing process.
• The fi lter holder (10) has a non-drip valve. The coffee jug (8) can also be re-
moved from the hotplate (7) during the brewing process. But beware: Place
the coffee jug (8) back on the hotplate (7) within 1 minute to prevent the
permanent fi lter (11) from overfl owing!
23 EN