Troubleshooting - DS Produkte CM-1609 Mode D'emploi

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does
not work. (Nothing
is shown on the
display.)
The fi lter holder (10)
overfl ows or the
device brews very
slowly.
The coffee jug (8)
overfl ows.
The device does not
brew any coffee.
The coffee does not
taste very good.
Timer function: The
device does not start
at the set time.
27
Possible cause / solution
• The mains plug is not inserted correctly in the plug socket.
• Is the plug socket defective? Try another plug socket.
• Check the fuse of the mains connection.
• There is too much coffee powder in the permanent fi lter
(11).
• The coffee powder is too fi nely ground.
• The permanent fi lter (11) or fi lter holder (10) is not inserted
correctly.
• The coffee outlet is blocked. Clean the fi lter holder (10).
• The coffee jug (8) is not positioned correctly on the hot-
plate (7).
• The device needs to be descaled (see the "Cleaning and
Descaling" chapter).
• The water tank is overfi lled. Note the MAX marking on the
water level indicator (6).
• The permanent fi lter (11) or the coffee bean container (3) is
not fi lled with coffee powder or coffee beans.
• Is the water tank empty?
• Has the Start / Stopp (start / stop) button (17) been
pressed?
• Has the device overheated? Wait a few minutes between
two brewing processes until the device has cooled down.
• The device needs to be cleaned or descaled (see the
"Cleaning and Descaling" chapter).
• The coffee powder is too coarsely or too fi nely ground.
• The ratio between the amount of coffee powder and water
is not correct.
• Poor quality of the coffee powder or water.
• Has the timer function been activated? (See the "Timer
Function" chapter)
EN