Iberital Expression Pro Manuel D'installation page 73

NOTE
If you have already entered programming mode and do not press any button to indicate a dose within
30 seconds, the button pad will go to stand-by position.
At this point programming can be started for the four coffee selections. When the desired quantity of coffee is obtained,
press the selection once again and the dosing will stop. The same operation will have to be followed for all buttons.
By carrying out this process all the groups will be programmed automatically.
NOTE
If we wish, we can operate in the same way for other groups, in order to set a customised dose for each
of the groups.
Iberital IB7
The selections that are already programmed will appear with their LEDs off. When this happens it is still possible to
modify the dose in the same manner as indicated above.
Iberital IB7
If the LED for the selection set is flashing during the programming of the dose, it means that the volume counter is not
sending a signal to the control unit, and at the end of the dosing the dose will be zero. Programming without water. It is
recommended that the flow meters be checked.
NOTE
If your model has a Display, you can see a screen indicating that it is in the programming menu.
INSTALLATION AND OPERATION MANUAL
Iberital Intenz
Iberital Intenz
Non-touchscreen display.
Doses setting
Select withing 30 s
Touchscreen display.
Manual doses
IBERITAL
New Iberital / Expression PRO
New Iberital / Expression PRO
71