Original Instructions - Dremel VersaFlame 2200 Traduction De La Notice Originale

GB

ORIGINAL INSTRUCTIONS

USED SYMBOLS
READ THESE INSTRUCTIONS
USE SAFETY EQUIPMENT. ALWAYS
WEAR EYE PROTECTION.
Before using the Dremel VersaFlame, make sure you read and
understand this manual completely.
WARNING
!
Failure to follow all instructions listed below may result in fire
and/or serious injury.
SAVE THESE INSTRUCTIONS
a. Keep work area clean and well lit. Cluttered and dark
areas invite accidents.
b. Do not keep combustible materials near the tool.
c. Keep children and bystanders away while operating the
tool. Distractions can cause you to lose control.
d. Only use the tool outdoors or in well-ventilated rooms.
PERSONAL SAFETY
a. Stay alert, watch what you are doing and use common
sense when operating the tool. Do not use the tool
while you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention while
operating tools may result in serious personal injury.
b. Use safety equipment. Always wear eye
protection. Safety equipment such as a dust
mask, non-slip safety shoes, hard hat and
hearing protection used for relevant conditions
will reduce personal injuries.
c. Do not overreach. Keep proper footing and balance at
all times. This enables better control of the power tool in
unexpected situations.
d. Dress properly. There is a danger of burning yourself
with the flame or with liquid soldering tin. Wear protective
clothing to protect yourself against burns. Keep your hair,
clothing and gloves away from the flame. Loose clothes or
long hair can catch fire.
READ ALL
INSTRUCTIONS.
WORK AREA
e. Secure the workpiece. Use a clamping device to hold the
workpiece. This allows you to use both hands to operate
the tool.
f. Keep this manual for future reference.
g. Do not use the appliance when it is leaking (gas smell),
shows any sign of damage or is malfunctioning.
h. If the appliance is leaking (gas smell) immediately
take it outside and check the leak-tightness without
a flame. Always use soapsuds. (Re)filling the gas
tank must be done in a well-ventilated place far away
from any possible sources of ignition, open flames,
pilot lights, electrical cookware and away from other
persons. Be sure to observe the safety instructions and
warning notices on the refill container. Do not make
any modifications to the tool.
i. Do not work materials containing asbestos (asbestos is
considered carcinogenic).
j. Take protective measures when during work dust can
develop that is harmful to one's health, combustible or
explosive (some dusts are considered carcinogenic);
wear a dust mask and work with dust/ chip extraction
when connectable.
TOOL USE AND CARE
a. Store your tool in an appropriate place with an ambient
temperature between 10°C and 50°C. Allow your tool to
fully cool down before storing. Unused tools should be
stored away from children in a dry location. Switch off
all unused tools.
b.
WARNING
!
before attaching or removing the accessories or before
cleaning.
c.
WARNING
!
d.
WARNING
!
e.
WARNING
!
temperature above 50ºC.
f.
WARNING
!
g.
WARNING
!
SERVICE
a. Have your tool serviced by a qualified repair expert
using only identical replacement parts. This will ensure
that the safety of the power tool is maintained.
4
Always switch off the tool and
allow it to fully cool down
Extremely flammable gas under
pressure.
Do not use near sparks or an
open flame.
Do not puncture or incinerate
the gas tank or store at a
Keep out of reach of children.
Do not try to disassemble this
unit.